Category: Uncategorized

.04.04.24

Separated and inventoried all the Lista cabinet/storage wall components. Most of it is counter-height, will need to decide which direction to go with countertops as these are cleaned and assembled into place.

standard-width drawers, standard depth
standard-width drawers, standard depth
mid-width drawers, standard depth
top and bottom panels, some end covers
top and bottom panels

18.03.24

LISTA cabinets.

LISTA 1

LISTA 2 (sold)

LISTA 3

LISTA 4

LISTA 4 EXT

LISTA 5

LISTA 6

LISTA 7

LISTA 8

LISTA 9

LISTA 10

LISTA 11

LISTA 12

LISTA 13

10.04.24

some sportster pictures for forum reference.

XLCR rear set bracket I made to run the rear set on an ’82
XLCR sprocket cover modified for the large pass-through bolt (previous pedal location.) Will need to notch for the starter bolt as shown.
crankcase cover/sprocket cover mismatch is pretty gross.

1980 ironhead cam cover works.

I’d like to backdate this side as well…

picked up a nice primary cover to modify & use with the XLCR rearset (peg post hole is going away entirely)
(printed section for visualization purposes)

20.9.21

the new couplers arrived; they’re beautiful, but the spline tolerances are too great (the factory sample is a slight press fit on the transfer case output – this is too loose):

additionally, the couplers seem to have a smaller ID than the sample (the original sample hasn’t been returned, but the other one I have access to has a larger OD) – I’m thinking about overall strength here…